Differences

This shows you the differences between two versions of the page.

--- commands:ahome [2023/12/15 12:07] – jon
+++ commands:ahome [2025/08/18 14:13] (current) – brandon
@@ Line 4: / Line 4: @@
 ^Shortcut  |AH   |
-^Format  |AH [X=fast_0] [Y=slow_0]  |
+^Format  |AHOME [X=fast_axis] [Y=slow_axis]  |
-^Units    |millimeters|
+^Units    |Millimeters|
-^Required Firmware Module    |ARRAY|
 ^Remembered |Using SS Z |
+^Required Firmware Module | [[:rapid_array_scanning|ARRAY MODULE]] |
 <--
@@ Line 14: / Line 14: @@
 ^Shortcut  |AH   |
-^Format  |[addr#]AH [X=fast_0] [Y=slow_0]  |
+^Format  |[addr#]AHOME [X=fast_axis] [Y=slow_axis]  |
-^Units    |millimeters|
+^Units    |Millimeters|
 ^Type    |Card-Addressed  |
-^Required Firmware Module    |ARRAY|
 ^Remembered |Using [addr#]SS Z |
+^Required Firmware Module | [[:rapid_array_scanning|ARRAY MODULE]] |
 <--
-Set the location of the first array position when using the [[:rapid_array_scanning|array module]].  The X setting is for the fast axis which is by default the X axis of the stage, but can be changed using the ''SN Y'' and ''SN Z'' settings (see [[commands:scan|SCAN]] command).
+Set the location of the first array position when using the [[:rapid_array_scanning|ARRAY MODULE]]. The X setting is for the fast axis which is by default the X axis of the stage, but can be changed using the [[commands:scan|SCAN]] command.
-Without arguments, the command reads the current location and sets it to the first array position.  When using arguments, ''fast_0'' and ''slow_0'' are coordinates expressed in millimeters.
+**No Arguments:** The command reads the current location and sets it to the first array position.
+**X:** ''[fast_axis]'' Set or query the fast axis home position in millimeters.
+**Y:** ''[slow_axis]'' Set or query the slow axis home position in millimeters.
+{{tag>array commands tiger ms2000}}
-{{tag>commands tiger ms2000 array}}

Address: 29391 W Enid Rd. Eugene, OR 97402, USA | Phone: +1 (541) 461-8181