Differences

This shows you the differences between two versions of the page.

--- commands:arm [2023/03/26 03:45] – remove sequencer tag brandon
+++ commands:arm [2023/03/28 13:31] (current) – Add update about the current state of functionality, remove params brandon
@@ Line 2: / Line 2: @@
 ^Shortcut  |ARM|
-^Format  |ARM  [X] [Y=log] [Z]|
+^Format  |ARM|
 ^Remembered |Using SS Z |
-Without arguments, this command establishes the **ARM_COMMAND_RCVD** event.  Typically it is used to start the SEQUENCER via a single serial command.
+Sending the ''ARM'' command without arguments starts the self-scanning of the ''ARRAY_MODULE'' sequence.
-**ARM X** re-initializes the SEQUENCER.  This command is useful if the RESET conditions are changed or if the sequencer is hung in a non-IDLE state.
-**ARM Y=1** turns on or ARM Y=0 turns off the serial log file creation.
-**ARM Z** forces a “sequence stop” condition.  The sequencer is re-initialized; all blocks with ALWAYS start conditions are placed in the IDLE state, and all stage motion is halted.
+This has the same effect as the [[commands:ARRAY|ARRAY]] command without arguments. It is recommended that you use  the ''ARRAY'' command instead of the ''ARM'' command.
+This command was previously related to the deprecated [[:sequencer|sequencer]] module.
 {{tag>commands ms2000}}

Address: 29391 W Enid Rd. Eugene, OR 97402, USA | Phone: +1 (541) 461-8181