commands:here
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| commands:here [2026/09/01 14:57] – put requirement for H M+ in correct spot brandon | commands:here [2026/09/01 15:42] (current) – add firmware requirements for clocked devices change position brandon | ||
|---|---|---|---|
| Line 31: | Line 31: | ||
| On clocked devices (filter slider, turret, mirrored port switch, etc), you can //change position #1// or you can //change the spacing between positions// | On clocked devices (filter slider, turret, mirrored port switch, etc), you can //change position #1// or you can //change the spacing between positions// | ||
| - | Change position #1: | + | Change position #1: <wrap lo> |
| - Remove all axes from either the joystick or a knob (for example, the Z-axis from the Z-knob <wrap cmd> J Z=0</ | - Remove all axes from either the joystick or a knob (for example, the Z-axis from the Z-knob <wrap cmd> J Z=0</ | ||
| - Assign the clocked device axis to that joystick or knob (for example, the M-axis to the Z-knob <wrap cmd> J M=22</ | - Assign the clocked device axis to that joystick or knob (for example, the M-axis to the Z-knob <wrap cmd> J M=22</ | ||
Address: 29391 W Enid Rd. Eugene, OR 97402, USA | Phone: +1 (541) 461-8181
commands/here.1788289045.txt.gz · Last modified: by brandon