Differences

This shows you the differences between two versions of the page.

--- commands:reset [2018/02/07 17:25] – jon
+++ commands:reset [2023/08/31 03:52] (current) – expanded brandon
@@ Line 1: / Line 1: @@
+====== Command:RESET (~) ======
+^Shortcut  |~   |
+^Format  |RESET|
+This command causes the controller to do a software reset.  A software reset re-initializes all variables back to their pre-assigned values and initializes all positions to 0.  Saved settings and system flags are preserved across resets, but not saved positions.  Therefore commands like [[commands:SETHOME|HM]] require a power cycle instead of a reset.  To re-initialize settings to default, use ''SS X'' before the reset (see documentation for the [[commands:saveset|SS command]]; note that on Tiger ''SS'' is a card-addressed command).
+== Example ==
+<asi> $ RESET
+:A</asi>
+--> Additional Notes about usage on Tiger ^
+RESET is usually a '' Broadcast command'' but can be used as a ''Card-Addressed Command'' as well. When addressed to a specific card, it resets that card and then the Comm card (required to communicate with the reset card) without affecting other installed cards.
+<--
+{{tag>commands tiger ms2000}}

Address: 29391 W Enid Rd. Eugene, OR 97402, USA | Phone: +1 (541) 461-8181